MTR3000 Base Station/Repeater: Description 1-3
Figure 1-1 Front view (with front bezel) of MTR3000 Base Station/Repeater
Figure 1-2 Front view (without front bezel) of MTR3000 Base Station/Repeater
Figure 1-3 Rear view of MTR3000 Base Station/Repeater
The MTR3000 model ships pre configured for analog conventional operation. Additional
configurations can be selected and created through the Customer Programming Software (CPS) on
a per-channel basis, based on the modulation type selected during station configuration.
Front Bezel
Front Panel LED Indicators
Speaker Port
Microphone Port
USB Port
Power Supply
Module
Power Amplifier
Module
Station Control Module
Exciter Module
Receiver Module
Backplane
Interface Board