47
Private Call
Private Call
General
A Private Call, also called Point-to-Point or individual call, is a
call between two individuals. No other terminal can hear the
conversation. This call can be a full-duplex call (if the system
allows) instead of the standard half-duplex call. In a full-
duplex call, both participants can speak at the same time,
while in a half-duplex call, only one person can speak at a
time.
For operating the MTH800 in RF sensitive areas, see “Trans-
mit Inhibit” on page 39.
Dual Microphone Feature
See “How to Hold Your MTH800” on page 13.
Making a Private Call
1. From the Home display dial a number.
2. If Private is not the first type of call pre-
sented, press CType to select the
Private Call type.
3. For a half-duplex call, press and release the
PTT button. You will hear a ringing tone. Wait
for the called person to answer your call. (This
is also called a hook setup.) OR,
Press and hold PTT. Wait for the talk permit tone (if configured)
before talking, and release the PTT when listening. (This is also
called a direct setup.)
While Transmit Inhibit is activated, an incoming Private Call is indi-
cated, but it is not possible to answer the call.
If you are in an on-going Group Call and wish to make a new call,
press to ignore the current call. Dial the number
.
Private #:
2234
Ctype Delete
6802972C35.book Page 47 Monday, August 16, 2004 9:22 PM
To Next Page
Loading...
