78
Incorrect Code Entered—You are prompted to try again. After
failing, your MTH800 will be blocked. Please check with your
Service Provider how many failed attempts are allowed.
How to unblock the MTH800
The display shows
Unit Blocked. You send or receive calls an
Emergency Call.
To unblock the MTH800, enter the PUK (Personal
Unblocking Key). The PUK is an eight-digit master code to be
obtained from your Service Provider.
After entering the PUK successfully, you will be prompted to
replace the forgotten code.
At the
New Code? prompt enter the new 4-digit code, and
repeat the code to confirm. If the code does not match, you
will be prompted to enter it again until the new code message
is accepted.
Change Code
From the main menu, select > Security > Change Code.
At the Old Code? prompt, enter the 4-digit code. If the old
code does not match the entered code at verification, the
display prompts you to re-enter the old code.
If the entered code matches the old code, the display
prompts you to enter a new 4-digit code and to repeat it for
confirmation. If the confirmation code does not match the
new code, the display prompts you to re-enter the new code.
When the new code is accepted, the display returns to the
Security sub-menu.
The default PIN code is 0000.
6802972C35.book Page 78 Monday, August 16, 2004 9:22 PM
To Next Page
Loading...
