64
Entering GPS Location Service
To enter the GPS sub-menu, press and
select More...> Location:
• Position provides the actual position infor-
mation.
• Interface allows you to enable/disable the
GPS location service.
• Testpage provides the actual satellite information.
Scroll to your selection and press
Select to access the next
display.
This estimate of accuracy of the calculated location is only a
very rough estimate and may vary substantially from the
actual accuracy of the approximate location information
reported.
Viewing Your Position
1. From the main menu, press and se-
lect More...> Location > Position.
2. Scroll to view the entire screen.
This displays the following information about
the last time your location was calculated (if available):
• The time the location was last calculated
• The latitude expressed in degrees, minutes, and seconds
• The longitude expressed in degrees, minutes, and sec-
onds
• The altitude expressed in meters
• The number of satellites used to calculate the location. In
general, more satellites make for better accuracy. The
maximum is twelve satellites.
To calculate your location again, press Rfrsh.
• The variation will vary in accordance to the GPS Configuration set by
your Service Provider.
• The availability of the GPS Location menus is dependent on your termi-
nal configuration, please contact your Service Provider for further
details.
Location
Interface
Position
Select Back
Testpage
M
E
N
U
Position
<Latitude>
<Time>
Rfrsh Back
<Longitude>
<Altitude>
<Tracked satellites>
M
E
N
U
6802972C35.book Page 64 Monday, August 16, 2004 9:22 PM
To Next Page
Loading...
