Moxa Technologies AWK Series - Page 39

AWK Series User Manual
39
New Password
Setting
Description
Factory Default
Min. 8 characters
Enter the password for this account.
For better protection, it is recommended to enforce stronger
password complexity by enabling the following Password
Policy requirements:
At least one digit (0-9)
At least one upper case letter (A-Z)
At least one lower case letter (a-z)
At least one special character (~!@#$%^&*-_|:;,.<>{}[]())
None
Confirm Password
Setting
Description
Factory Default
Password
Enter the account password again for confirmation.
None
Email
Setting
Description
Factory Default
Email
Enter the email address for this account.
None
Role
Setting
Description
Factory Default
Administrator
Set the user’s role to Administrator. This role provides full
access to all configurations on the device. (pre-defined
authority)
User
Engineer
Set the user’s role to Engineer. (pre-defined authority)
User
Set the user’s role to User. (pre-defined authority)
Custom
If a mix of authorities is necessary, create an account via the
Custom option and manually select the necessary authorities
for this account.
Authority
Setting
Description
Factory Default
Checkbox
Checking authorities gives the user the ability to access
configurations pages in the corresponding category. These
authority privileges extend to all access interfaces, including
CLI.
None
Refer to the table below for an overview of each role and corresponding authorities.
Authority
Admin
Engineer
User
Account System
Yes
No
No
Advanced Diagnostic
Yes
Yes
No
Auditor System
Yes
Yes
No
Diagnostic
Yes
Yes
Yes
Network
Yes
Yes
No
Status Monitoring
Yes
Yes
Yes
System Backup
Yes
No
No
System Management
Yes
Yes
No
NOTE
The Administrator, Engineer, and User roles have pre-defined authority options and cannot be changed.
The Administrator has all authorities enabled by default. The Custom role allows you to select specific
authorities for the user account.
Refer to Appendix D for a detailed overview of the required authority for each device feature or service to
determine the privilege requirements when setting up an account.
When finished, click APPLY to create a new account.