Moxa Technologies MiiNePort E2-H - Page 96

MiiNePort E2/E3 Introduction to SCM (Serial Command Mode) Command Set
A-4
NECI (utility accessibility)
Command code: BU
Command parameters: N/A
Reply parameters: 1 if NECI is enabled, 0 otherwise.
?GBU
System requests NECI setting for this MiiNePort.
!GBU01
MiiNePort reports NECI as ‘Enable’.
IP configuration
Command code: NC
Command parameters: N/A
Reply parameters: MiiNePort’s IP configuration index as follows.
0 Static
1 DHCP
2 DHCP/BOOTP
3 BOOTP
4 AUTOIP
?GNC
System requests IP configuration for this MiiNePort.
!GNC00
MiiNePort reports IP configuration as ‘Static’.
IP address
Command code: NI
Command parameters: N/A
Reply parameters: MiiNePort’s IP address.
?GNI
System requests IP address for this MiiNePort.
!GNI0192.168.127.254
MiiNePort reports IP address as ‘192.168.127.254’.
Netmask
Command code: NM
Command parameters: N/A
Reply parameters: MiiNePort’s Netmask address.
?GNM
System requests Netmask address for this MiiNePort.
!GNM0255.255.255.0
MiiNePort reports netmask as ‘255.255.255.0’.
Gateway
Command code: NG
Command parameters: N/A
Reply parameters: MiiNePort’s Gateway address.
?GNG
System requests Gateway address for this MiiNePort.
!GNG0255.255.255.255
MiiNePort reports Gateway address as ‘255.255.255.255’.