MiiNePort E2/E3 Introduction to SCM (Serial Command Mode) Command Set
DNS
Command code: ND
Command parameters: The index (1 or 2) of DNS server.
Reply parameters: MiiNePort’s DNS address.
?GND1
System requests DNS server 1 address for this MiiNePort.
!GND0192.168.1.2
MiiNePort reports DNS server 1 address as ‘192.168.1.2’.
PHY Speed
Command code: NS
Command parameters: N/A
Reply parameters: MiiNePort’s PHY speed as follows:
0 PHY auto negotiation is enabled.
10 PHY speed is forced to 10Mbps with half duplex
11 PHY speed is forced to 10Mbps with full duplex
100 PHY speed is forced to 100Mbps with half duplex
101 PHY speed is forced to 100Mbps with full duplex
?GNS
System requests PHY speed setting for this MiiNePort.
!GNS00
MiiNePort reports PHY speed determined by PHY auto negotiation function.
Enable/Disable SNMP
Command code: MS
Command parameters: N/A
Reply parameters: 1 (Enable) or 0 (Disable) MiiNePort’s SNMP agent.
?GMS
System requests Enable/Disable SNMP agent for this MiiNePort.
!GMS01
MiiNePort reports SNMP agent as ‘Enable’.
Community String
Command code: MU
Command parameters: N/A
Reply parameters: MiiNePort’s SNMP Community string.
?GMU
System requests SNMP community string for this MiiNePort.
!GMU0public
MiiNePort reports SNMP community string as ‘public’.
Contact Name
Command code: MN
Command parameters: N/A
Reply parameters: MiiNePort’s SNMP Contact Name.
?GMN
System requests SNMP contact name for this MiiNePort.
!GMN0s_name
MiiNePort reports SNMP contact name as ‘s_name’.
To Next Page
Loading...
