Moxa Technologies MiiNePort E2-H - Page 99

MiiNePort E2/E3 Introduction to SCM (Serial Command Mode) Command Set
A-7
Baudrate
Command code: SB
Command parameters: Port index.
Reply parameters: MiiNePort’s Baudrate.
?GSB1
System requests port 1’s Baudrate for this MiiNePort.
!GSB0115200
MiiNePort reports Baudrate as ‘115200’.
Data bits
Command code: SD
Command parameters: Port index.
Reply parameters: MiiNePort’s Data bits.
?GSD1
System requests port 1’s Data bits for this MiiNePort.
!GSD08
MiiNePort reports Data bits as ‘8’.
Stop bits
Command code: SS
Command parameters: Port index.
Reply parameters: MiiNePort’s stop bits index.
Stop Bits Index Table:
0 Stop bits is 1
1 Stop bits is 1.5
2 Stop bits is 2
?GSS1
System requests port 1’s Stop bits for this MiiNePort.
!GSS00
MiiNePort reports Stop bits as ‘1’.
Parity
Command code: SP
Command parameters: Port index.
Reply parameters: MiiNePort’s Parity index as follows.
0 None
1 Odd
2 Even
3 Mark
4 Space
?GSP1
System requests port 1’s Parity for this MiiNePort.
!GSP00
MiiNePort reports Parity as ‘None’.