Multiplex SMART SX - Handling the SMART SX System; Transmitter Controls Layout; Receiver Controls and Connections; Transmitter Aerial Technology

SMART SX
_________________________________________________________________________________________________________
Page 21
SMART SX instructions # 985 5
3
35 (LA 14.07.2015) • Errors and omissions excepted •

MULTIPLEX
Dimensions (L x W x H): approx. 193 x 148 x 53 mm
6.2 RX-5 light M-LINK receiver
Servo channels: 5
Connector system: UNI
Receive system: 2.4 GHz FHSS
Operating voltage: 3.5 V … 9.0 V
Power supply: 4 - 6 NiXX cells, 2S LiXX
Permissible operating
temperature range: - 20
o
C … + 55
o
C
Weight: approx. 7 g
Dimensions (L x W x H): approx. 34 x 19.5 x 11 mm
7.1 Transmitter controls
7.2 Receiver controls
7.3 Transmitter aerial
The transmitter is fitted with an aerial exploiting the new,
patented IOAT tech-nology. The integral aerial exhibits a
7. H ANDLING
On / Off switch (button)
with Status LED
Switched channel 6
(Mode 1 + 3)
Elevator trim (Mode 2 + 4)
Elevator / rudder stick
(Mode 1 + 3)
Throttle / aileron stick
(Mode 2
+
4)
Throttle / aileron
stick (Mode 1 + 3)
Elevator / rudder
stick (Mode 2 + 4)
Aileron trim
(Mode 1 + 3)
Rudder trim
(Mode 2 + 4)
Rudder trim
(Mode 1 + 3)
Aileron trim
(Mode 2 + 4)
Multifunc-
tion button
Switched channel 6
(Mode 2 + 4)
Elevator trim
(Mode 1 + 3)
Inte
g
ral IOAT aerial
Transmitter with integral buzzer for audible
feedback
Battery compartment with cells fit-
ted (always maintain correct cell
polarity, as shown in this photo)
PC communication port with USB lead (#
85149).
Status LED
SET button
Servo sockets,
channels 1 - 5
2.4 GHz aerial, do not bend sharply,
deploy active end in a straight line