8-6 sp e c I a L f e a t u r e s
8
Enter the macro name by using the numeric keys. (If necessary, review “Entering
characters” page 2-2) It can be store up to 130 characters.
9
Press <Enter> to finish.
NOTE: To print a list of macro keys, press <Menu>, <5>, <1>, <1>, <8>, then <Enter>.
Erasing a macro key
1
Press <Macro Program> twice.
2.Erase Macro
/
/Enter
2
Press <Enter>.
3
Press the macro key you want to erase.
4
Press <Enter>. The following two displays will appear:
M1:Erase Macro
Yes Enter
M1:Erase Macro
No Cancel
5
Press <Enter> to erase the macro.
If you want to quit without erasing, press <Cancel>.
6
To erase another macro, repeat procedures from step 3.
Press <Reset> to return to standby mode.
Macro key speed
You can adjust the macro key speed.
1
Press <Macro Program> three times.
3.Macro Speed
/
/Enter
2
Press <Enter>.
3
Press <q> or <p> to select the mode you want appears. The possible settings are
“Normal”, “Slow” or “Fast”.
4
Press <Enter> to save the setting.
5
Press <Reset> to exit.
To Next Page
Loading...
Need help?
General
