Muratec F-315 - Initial Setup; Clearing Stored Settings; Getting Started

1-13La y o u t & In s t a L L a t I o n
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
La y o u t & In s t a L L a t I o n
Initial setup
Clearing stored settings
Before using your machine, clear the built-in user data. This ensures that the memory
will hold only your settings.
IMPORTANT: After specifying the initial settings, do not clear the memory again without an
authorized technician’s advice.
To clear the memory:
1
Press <Menu>, <
*
>, <0>, then <2>.
Clear User Settings
Yes  Enter
Clear User Settings
No  Cancel
2
If you want to clear the memory, press <Enter>.
If you do not want to clear the memory, just press <Cancel>.
Getting started
In some countries you are required by law to indicate your name and fax number on
every fax you send.
YOU MUST THEREFORE STORE YOUR NAME (OR COMPANY NAME) AND
FAX NUMBER IN YOUR MACHINE BEFORE USING IT.
Every fax page you send arrives at the receiving machine with a single line of text at
the very top of the page. This text lists a name, called the Transmit Terminal Identifier
(TTI), and a fax number.
Under “Specifying initial settings” below, you can stored the following items including
your name and fax number.
•Language
•Currentdateandtime
•Automaticdaylightsavingtimedetection
•Faxreceptionmode
•Dialtonedetection
•Phonedialingtype
•Yourfaxnumber
•TTI1/TTI2/TTI3
•UsualTTI
•Ecomode
The settings you adjust here can always be changed later.