3-10 au t o d I a L L e r & dI a L L I n G o p t I o n s
Erasing a call group
1
Press <Menu>, <1>, <3>, <2>, then <Enter>.
2
Press <q> or <p> to select the call group you want to erase.
You can also select the call group by directly entering the two-digit identifier code
(01-32).
3
Press <Enter> twice.
If you want to exit without erasing, press <Cancel>.
4
To erase another call group, repeat the procedure from step 2.
Otherwise, press <Reset> to exit and return to the standby mode.
How to dial using a call group
Press this key twice.
Enter group number.
Press <Start>.
MFX-1950 control panel
To perform call group fax dialing
1
Switch to the fax mode by pressing
<
c o p y
4
f a x
4
s c a n
>
.
2
Place the document on the ADF or the document glass.
3
When you use the document glass, select the document size by pressing <Doc. Size>.
4
Adjust the document resolution and contrast.
5
Press <Speed Dial /Group> twice.
Enter Group No.
G_
6
Use the numeric keys to enter the two-digit call group number.
7
Press <Start>.
NOTE: The document glass is available only for the MFX-1950.
To Next Page
Loading...
Need help?
General
