10-4 us e r s e t t I n G s
Fax settings
The fax settings allows you to customize various fax settings to match your needs.
Accessing the fax settings
1
Press <Menu>, <2>, <2>.
[Program] No.22_
2 Fax Settings
2
Press <Enter>.
[Program] No.2201
01 Scan Parameters
3
Use <q> or <p> to search the item you want to set or change and press <Enter>.
4
Change settings and press <Enter>. For details of each setting, refer to the table
below:
5
When you have finished, press <Reset> to return to the standby mode.
The underlined settings are factory defaults.
01. Scan Parameters
Resolution You can choose one of the following.
Normal Scan at 8 dots/mm × 3.85 lines/mm
Fine Scan at 8 dots/mm × 7.7 lines/mm
S-Fine Scan at 8 dots/mm × 15.4 lines/mm
Gray Scan at 8 dots/mm × 7.7 lines/mm
Contrast You can choose one of the following.
Normal, Dark, Darkest, Light or Lightest.
S-Fine Resol. You can choose one of the following.
400dpi, 600dpi
02. Print Parameters
Rx Reduc. Rate See page 5-6.
Auto Automatically reduces printouts at variable
rates down to a minimum of 50%. Tries to
reduce printout to fit on one sheet of your
selected paper size. If it can’t, print the
received document at 100% size on two or more
pages.
100% Does not reduce the received documents.
Margin Sets the reduction margin for Auto reduction. (00 to 85 mm)
40 mm
Half Page Recpt.*
Off Will not combine the half-page receptions.
On Combines two of half-page receptions onto a
single sheet.
* When the MFX-1950, the following menu will be displayed.
Paper Save
Off Will not perform either half-page receptions or
duplex receptions.
H.Page Rx Combines two half-page receptions onto a single
sheet.
Duplex Rx Combines and prints the received two one-sided
pages onto both sides of a single sheet.
To Next Page
Loading...
