Muratec F-315 - Troubleshooting; Document Jams

12-8 Ma I n t e n a n c e & pr o b L e M s o L v I n G
Troubleshooting
Document jams
Case 1:
If a document jams in the ADF, the following message will be displayed.
Open&Close ScanCover
Reset Document
Also, if a document jam occurs during a quick memory transmission or real time trans-
mission, the following check message will be printed to tell you which page is jammed.
Case 2:
If a document jams while scanning into memory for sort copy or normal memory trans-
mission, the machine will show:
Document Jam
ContStor Enter/Cancl
1
If you want to continue the operation, press <Enter> and proceed to step 2.
To abort the operation, press <Cancel>.
NOTE: If the machine is left idle for 3 minutes, the machine will abort the operation auto-
matically
2
The machine will show which page (i.e., which page number) is jammed. Clear the
document jam and reset document in the ADF from the jammed page forward, then
press <Start>.
p 2. Reset Document
Press Start key
NOTE: • Ifthemachineisleftidlefor3minutes,themachinewillbegintosendorcopy
the document(s) it has.
 •Ifyouwishtocancelthisoperation,press<Stop>.Themachinewilldeleteall
pages from memory and then return to the standby mode.