Muratec F-315 - Page 52

2-14 Ge t t I n G s t a r t e d
NOTE: When setting paper longer than letter paper size, remove the guide stopper from the
back of the end guide, and then replace and secure it on the groove in front of the
end guide (the guide stopper will be under the paper).
F4
A4
11
LTR
14
The guide stopper
4
Load the paper into the cassette.
•Beforeyouinsertpaperinthecassette,stackitsotheleadingedgeandsidesof
the paper are even.
•Donotstackthepaperoverthelimitmarkinsideofthecassette.
NOTE: To prevent paper jams, do not refill this paper cassette without first removing any
remaining paper. In other words, do not just add sheets to an already-loaded stack.
5
Pinch the side paper guide and adjust to the width of the stack.
6
Close the paper cassette.
7
After loading paper in the paper cassette, you need to set the paper size.
(See “Setting of the paper size” on page 2-16.)
8
Attach the paper size sticker supplied with your machine to the front of the cassette.