▪ The Nudge Grid is active only when the Step Grid is active. If the Step Grid is disabled,
nudging events will shift them at the maximum resolution of the sequencer.
▪ By default, the Nudge Grid resolution is half a step, meaning that events will be nudged by
half a step at a time.
▪ If you set the Nudge Grid resolution to a full step, the Nudge Grid will mirror the Step Grid
and you can nudge events with the same resolution as when creating or quantizing events.
▪ You can also set the Nudge Grid resolution to a smaller fraction of the Step Grid resolution.
This allows you to nudge events with even finer increments.
To change the Nudge Grid’s settings:
1. Press the GRID button.
2. Turn the Encoder to select NUDGE.
3. Press the Encoder to select the NUDGE parameter.
4. Turn the Encoder to select a new value.
→ A new Nudge value is selected.
Recording and Editing Patterns
Editing a Pattern
MASCHINE JAM - Manual - 112
To Next Page
Loading...