3. Press any number of click-pads (1–16) to mute Sounds. Press the click-pads again to turn
mute off.
→ Selected Sounds are muted or returned to the mix.
Pinning allows a mode to remain selected without the need to hold the mode button, for
example, press MUTE + SONG to pin Mute mode. You can now use both hands to ma-
nipulate the controls of MASCHINE JAM. Click MUTE again to exit the pinned Mute
mode.
10.1.5 Adjusting Aux Send
Each Sound or Group of your Project provides two auxiliary outputs that you can route to addi-
tional targets. For example, you can send a definable amount of the channel’s audio output to
other channels for further processing. This is notably used in send effects. The auxiliary out-
puts of a Sound/Group are configured on the Aux page of the Output properties in the software.
MASCHINE JAM allows you to control the Aux levels for each Group and Sound.
Adjusting the Aux Level of a Group
To adjust the Aux level of a Group:
1. Press and hold the AUX button.
⇨ The Smart Strips act like faders and the LEDs indicate the level of each Group. If neces-
sary, use the D-pad Left or Right buttons to access other Group banks.
Mixing Your Song
Basic Functions
MASCHINE JAM - Manual - 146
To Next Page
Loading...
Need help?
General
Weight and Dimensions
