3. Press and hold a Section button (1-8) to select the start point for the loop, and then press
another Section button to select the end point for the loop.
⇨ All Section buttons in the selected Loop range will illuminate.
4. Press PLAY to hear the Sections.
⇨ The Song will play and then repeat in the loop range.
5. Press SHIFT + Page Right button (LOOP) to turn loop off.
→ Playback will continue until it is stopped. The loop range can be altered at any time by
repeating the procedure and adding new start and end points.
You can also press and hold a Section button then press and turn the Encoder to set a
loop range.
Arranging Your Song
Looping Sections
MASCHINE JAM - Manual - 135
To Next Page
Loading...