Pattern View
Use Pattern view to navigate the Pattern Editor in the MASCHINE software:
1. Press and hold the VIEW button to enter View mode. You can also press VIEW + MAIN to
pin the View mode so that you can release the VIEW button and stay in View mode (see
↑10.1.1, Controller Modes and Mode Pinning).
2. Press F2 to select PAT (for “Pattern”) and use the pads in the table below to navigate the
Pattern Editor view.
Shortcuts for navigating the Pattern Editor from the MASCHINE MIKRO controller.
Action Shortcut
Hide/view Browser Press pad 13
Hide/view Control Lane Press pad 14
Quick Reference
Using Your MASCHINE Controller
MASCHINE MIKRO - Getting Started - 153
To Next Page
Loading...
