▪ The newly pressed pad is fully lit. If you release GROUP the pads can be used to trigger
the Sounds of the selected Group. Since we haven’t loaded anything in the other Groups
yet, all the pads are unlit, except one of them (indicating that it is currently selected).
As you can see, MASCHINE communicates in both directions: The commands you give via the
pads and buttons control the software, but the software also communicates information back
to you via the display and the LEDs.
►
Select the Group A again by pressing GROUP + pad 13 (A) and continue playing on the
pads to get familiar with them.
When you feel ready, move on to the next section, where we will record a little rhythmic pattern
using this drum kit!
2.3 Recording Your First Pattern
Now that you feel comfortable with the pads, let’s use them to live record some rhythm into a
Pattern. A Pattern is a recorded sequence of notes played on the Sounds of the current Group.
In each Group you can have an unlimited number of Patterns which are grouped into Pattern
banks containing up to 16 Patterns each.
We will now use the transport controls, which are located at the bottom left of your controller:
The TRANSPORT section on your controller.
First Steps
Recording Your First Pattern
MASCHINE MIKRO - Getting Started - 26
To Next Page
Loading...
Need help?
General
