Native Instruments Maschine MIKRO Getting Started

10.3.1.1 CONTROL Section
This section gives an overview of the CONTROL section.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Overview of the CONTROL section.
(1–3) F1, F2 and F3 buttons: The three buttons above the LCD display dynamically adapt their
function to the active mode, allowing direct access to the most important sub-sections and
functions. The action they will perform is shown below each button in the display. Using the
SHIFT button you can also use F1 to access MIDI mode and F2 to access Instance mode:
▪ MIDI mode: In this mode you can use MASCHINE MIKRO as a MIDI controller. Press SHIFT
+ F1 to access MIDI mode. For more details, please refer to the Controller Editor manual.
▪ Instance mode: In this mode you can select which instance of the MASCHINE plug-in you
want to control from your hardware controller if you have more than one instance open in
your Digital Audio Workstation (DAW). Press SHIFT + F2 to access Instance mode. Turn
the Control encoder (6) to select an instance and press it to connect your controller to that
instance.
(4) MAIN button: Press the MAIN button to switch between Control mode and Main mode:
Quick Reference
MASCHINE Hardware Overview
MASCHINE MIKRO - Getting Started - 159

Native Instruments Maschine MIKRO Specifications

General

Brand	Native Instruments
Model	Maschine MIKRO
Category	Telephone
Language	English