Native Instruments Maschine MIKRO Getting Started

4.2.2.1 Adjusting Pattern Length in the MASCHINE Software
In the software, you can change the Pattern Length in two ways:
►
In the timeline of the Pattern Editor, click the right limit of the Pattern (indicated by a
little triangle pointing to the left) and drag your mouse horizontally in the timeline to
change the Pattern Length.
►
At the top right of the Pattern Editor, click the value and drag your mouse vertically to
change the Pattern Length.
4.2.2.2 Adjusting the Pattern Length using the Controller
1. Press PATTERN and hold it.
At the bottom of the display, you see that the LENGTH parameter is currently set to
1:0:0, which means one bar.
2. While holding PATTERN, turn the Control encoder to set a new value for the Pattern
Length.
Creating Beats
Adding a Second Pattern
MASCHINE MIKRO - Getting Started - 66

Native Instruments Maschine MIKRO Specifications

General

Brand	Native Instruments
Model	Maschine MIKRO
Category	Telephone
Language	English