Native Instruments Maschine MIKRO Getting Started

1. Click the Osc2 label at the top of the Control area to select the Osc2 parameter page.
The Control area now displays the parameters of that page.
2. Click the fourth knob (Osc2Amp) and drag your mouse vertically to adjust the value.
You can fine-adjust the parameter value by holding down [Shift] on your computer key-
board while you drag the mouse!
5.5.2 Accessing the Plug-in Parameters using the Controller
1. Press F3 to select SOUND.
This displays parameters for the selected Sound slot.
2. If the Sound slot 1 containing our “Analovue” Sound is not currently selected, select it by
pressing SELECT + pad 1.
3. Press NAV + F3 to select PLUG-IN (more on this later).
The display should now look like this:
→
You now have access to the parameters of your bass Sound “Analovue.” At the bottom of
the display, the selected parameter and its value are displayed.
The selected parameter and its value displayed at the bottom of the display.
Adding a Bass Line
Accessing the Plug-in Parameters
MASCHINE MIKRO - Getting Started - 87

Native Instruments Maschine MIKRO Specifications

General

Brand	Native Instruments
Model	Maschine MIKRO
Category	Telephone
Language	English