34
To select a locomotive for operation:
Press the SELECT LOCO button
Enter the 1 to 4 digit address of the loco/consist to be operated. A “Leading Zero”
is necessary for long addresses below 128. An asterisk will be displayed before any
long address below 128 (example below).
Press the ENTER key.
Locomotive address examples:
4421 = Long Address
006 = Long Address as entered.
*006 = Long Address as displayed
45 = Short Address as entered
045 = Short Address as displayed
LOC: will be displayed when addressing a single locomotive
CON: will be displayed when addressing a Consist.
CONTROLLING HEADLIGHTS AND
OTHER DECODER FUNCTIONS
Pressing HEADLIGHT will alternately toggle the headlight of the locomotive on and off.
To toggle other functions simply press the number key that corresponds to the function
you wish to control. E.g. - The ‘1’ key controls function 1.
Your cab will display which functions are on and off on the lower right of the display. The
letter ‘L’ stands for Headlight (Function 0) and numbers 1-6 stand for functions 1-6
(functions 7 through 12 are not displayed on the cab but work if you push the buttons).
In the example below the headlight plus functions 2 and 6 are on.
LOC:4449 xx:xxPMLOC:4449 xx:xxPM
LOC:4449 xx:xxPMLOC:4449 xx:xxPM
LOC:4449 xx:xxPM
FWD:02 L-2---6FWD:02 L-2---6
FWD:02 L-2---6FWD:02 L-2---6
FWD:02 L-2---6
Control of functions F13-F28 has been added. To access these function numbers
program the OPTION key of any cab to a value of 122. Pressing OPTION will display
F10-F19 on the botom line of the Pro Cab LCD. Pressing a digit will then toggle that
function number plus ten. For example pressing 6 will issue an F16 command.
Pressing OPTION a second time will display F21-F28 on the LCD. Pressing a digit with
this display will toggle that function number plus twenty.
Pressing OPTION a third time will return to the F10-F19 display.
Pressing PROG/ESC at any time will abort the operation.
To Next Page
Loading...
