67
NUMBER OF PROGRAM PACKETS
This adjusts the number of times a programming command is sent when programming a
locomotive on the mainline. Factory default is 4. Press ENTER to skip setting this
parameter.
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PM
OF PROG PKTS 004OF PROG PKTS 004
OF PROG PKTS 004OF PROG PKTS 004
OF PROG PKTS 004
TEST FOR LOCO IN USE
If set to YES, a warning will be issued if you select a loco that is in use by someone else.
If set to NO, no warning is issued. Factory default is no. Press ENTER to skip setting this
parameter.
TEST FOR LOCO INTEST FOR LOCO IN
TEST FOR LOCO INTEST FOR LOCO IN
TEST FOR LOCO IN
USE? 1=Y 0=N 0USE? 1=Y 0=N 0
USE? 1=Y 0=N 0USE? 1=Y 0=N 0
USE? 1=Y 0=N 0
SEND FUNCTION COMMANDS TO CONSIST ADDRESS
Function commands are normally sent to the lead loco of an advanced consist. They can
also be sent to the consist address so that other locomotives in consist can react to
these commands if desired. The factory default is yes. Press ENTER to skip setting this
parameter.
SEND FUNCTION TOSEND FUNCTION TO
SEND FUNCTION TOSEND FUNCTION TO
SEND FUNCTION TO
CON? 1=Y 0=N 1CON? 1=Y 0=N 1
CON? 1=Y 0=N 1CON? 1=Y 0=N 1
CON? 1=Y 0=N 1
CONSIST MOMENTUM
You can disable the momentum button on all handheld cabs that are operating a
consist. The buttons are enabled by factory default. Press ENTER to skip setting this
parameter.
SEND FUNCTION TOSEND FUNCTION TO
SEND FUNCTION TOSEND FUNCTION TO
SEND FUNCTION TO
CON? 1=Y 0=N 1CON? 1=Y 0=N 1
CON? 1=Y 0=N 1CON? 1=Y 0=N 1
CON? 1=Y 0=N 1
MOMENTUM MULTIPLIER
When you press the MOMENTUM button you are prompted for a single digit indicating
how much momentum you want for the loco/consist you are controlling. Momentum CVs
have a range of 0-255 while the button asks for values from 0-9.
MOMENTUM BUTTONMOMENTUM BUTTON
MOMENTUM BUTTONMOMENTUM BUTTON
MOMENTUM BUTTON
MULTIPLIER: 08MULTIPLIER: 08
MULTIPLIER: 08MULTIPLIER: 08
MULTIPLIER: 08
The value you enter for the momentum button is multiplied by this parameter (factory
default of 8) and sent to CV3 in the locomotive. This parameter adjusts the multiplication
factor. You can set it from 0-25. Press ENTER to skip setting this parameter.
MOMENTUM DECELERATION RATE
The deceleration rate (CV4) when pressing the momentum button can be either half the
value sent for acceleration (CV3) or the full value sent to CV3. Factory default is ½.
Press ENTER to skip setting this parameter.
MOMEN DECEL RATEMOMEN DECEL RATE
MOMEN DECEL RATEMOMEN DECEL RATE
MOMEN DECEL RATE
1=FULL 0=HALF 01=FULL 0=HALF 0
1=FULL 0=HALF 01=FULL 0=HALF 0
1=FULL 0=HALF 0
To Next Page
Loading...
