55
ASSIGNING A LOCO TO A CAB
(shortcut = PROG 2 )
This selection passes a loco from one cab to another. This is especially useful when the
other operator is a novice or has a Basic Cab. The locomotive/consist is passed to the
assigned cab and the locomotive/consist controlled by the other cab is passed back to
the original cab. In effect the locomotives controlled by the cabs are “swapped”. This way
you will not accidentally ‘lose’ a locomotive in the system.
ASSIGN THE LOCO
Enter the loco/consist number you want to assign to another cab, then press ENTER. If
you want to assign the loco you are currently running just push ENTER.
ASSIGN 02:00PMASSIGN 02:00PM
ASSIGN 02:00PMASSIGN 02:00PM
ASSIGN 02:00PM
WHICH LOCO: _003WHICH LOCO: _003
WHICH LOCO: _003WHICH LOCO: _003
WHICH LOCO: _003
ASSIGN THE CAB
You need to know the address of the cab you want to ‘receive’ the loco you are
assigning. Enter the Cab number then press ENTER.
LOC:1234 02:00PMLOC:1234 02:00PM
LOC:1234 02:00PMLOC:1234 02:00PM
LOC:1234 02:00PM
TO WHICH CAB? _TO WHICH CAB? _
TO WHICH CAB? _TO WHICH CAB? _
TO WHICH CAB? _
This operation is also useful to transfer an old style consist to a smaller cab without the
capability of setting up consists.
To Next Page
Loading...
