40
FOLLOW-UP SCREEN
CON: 012 02:00PMCON: 012 02:00PM
CON: 012 02:00PMCON: 012 02:00PM
CON: 012 02:00PM
CONSIST NOW FULLCONSIST NOW FULL
CONSIST NOW FULLCONSIST NOW FULL
CONSIST NOW FULL
This screen reaffirms the previous screen. Press the ENTER key to continue.
CON: 042 2:00PMCON: 042 2:00PM
CON: 042 2:00PMCON: 042 2:00PM
CON: 042 2:00PM
008R 101 4449R 008R 101 4449R
008R 101 4449R 008R 101 4449R
008R 101 4449R
The R indicated that the loco is reversed in the consist.
Loco 42is the lead loco (short address of 42).
Loco 8 is a loco operating backwards.
Loco 101 is a locomotive operating forward.
Loco 4449 is a locomotive operating backwards.
ADDING A LOCO TO AN OLD STYLE CONSIST
CON: 012 2:00PMCON: 012 2:00PM
CON: 012 2:00PMCON: 012 2:00PM
CON: 012 2:00PM
FWD: 000 L------FWD: 000 L------
FWD: 000 L------FWD: 000 L------
FWD: 000 L------
With an Old Consist, you can only add a loco to an active consist on your cab. If the
consist is not active press RECALL until you have the consist active or acquire the
consist from another cab by “ASSIGN LOCO TO CAB”.
ENTERING THE LOCO NUMBER
CON: 012 2:00PMCON: 012 2:00PM
CON: 012 2:00PMCON: 012 2:00PM
CON: 012 2:00PM
ADD LOCO: _ADD LOCO: _
ADD LOCO: _ADD LOCO: _
ADD LOCO: _
Enter the loco number to add and press ENTER.
ENTERING THE LOCO DIRECTION
CON: 012 2:00PMCON: 012 2:00PM
CON: 012 2:00PMCON: 012 2:00PM
CON: 012 2:00PM
DIR THIS LOCO: FDIR THIS LOCO: F
DIR THIS LOCO: FDIR THIS LOCO: F
DIR THIS LOCO: F
If the locomotive is to operate in the forward direction press ENTER. Press the
DIRECTION key if you wish to have the locomotive operate in the reverse direction.
Subsequent presses of the DIRECTION key will keep changing the direction. When you
get the direction you desire press the ENTER key.
DROPPING A LOCO FROM AN OLD STYLE CONSIST
CON: 012 2:00PMCON: 012 2:00PM
CON: 012 2:00PMCON: 012 2:00PM
CON: 012 2:00PM
FWD: 120 L------FWD: 120 L------
FWD: 120 L------FWD: 120 L------
FWD: 120 L------
You can only delete a loco from an active consist on your cab. If the consist is not active
press RECALL until you have the consist active or acquire the consist from another cab
by “ASSIGN LOCO TO CAB”.
Press DEL.
To Next Page
Loading...
