NCE Power Pro - Copyrights; Warranty

66
SETUP COMMAND STATION
(Shortcut = PROG 5)
This allows the operator to view the Command Station’s version number and set various
system (not decoder) parameters. If you press “28882” at the “SET CMD STATION”
prompt the command station will be reset to all original factory settings.
DISPLAY SOFTWARE VERSION AND DATE
This screen is important when the time comes to call or write about a question or a
problem.
VERSION: 01:30AMVERSION: 01:30AM
VERSION: 01:30AMVERSION: 01:30AM
VERSION: 01:30AM
WED MAR 1 2007WED MAR 1 2007
WED MAR 1 2007WED MAR 1 2007
WED MAR 1 2007
The following screens are available should a need arise to change any of the factory
settings. There is probably no reason to ever change these settings. If you get things
REALLY messed up you can reset the system to original factory settings (see paragraph
above).
NUMBER OF STOP PACKETS
This adjusts how many times a stop command is sent to the Loco. If you have a large
layout or run more than about 40 different locomotives in a session we recommend
setting this to 8. This will automatically purge non-necessary speed 0 commands from
being sent to the track increasing system response to throttle commands.
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PM
OF STOP PKTS 008OF STOP PKTS 008
OF STOP PKTS 008OF STOP PKTS 008
OF STOP PKTS 008
If set to zero all speed 0 commands will continue to be circulated for every locomotive
that has been controlled (but now is stopped) since the system was last turned on.
Factory default is 8. Press ENTER to skip setting this parameter.
NUMBER OF TEMP PACKETS
This adjusts the number of Function control commands that are sent when a Function
control button is pressed. Factory default is 5. Press ENTER to skip setting this
parameter.
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PM
OF TEMP PKTS 005OF TEMP PKTS 005
OF TEMP PKTS 005OF TEMP PKTS 005
OF TEMP PKTS 005
NUMBER OF ACCESSORY PACKETS
This adjusts the number of accessory control commands sent when an accessory or
signal is controlled. Factory default is 4. Press ENTER to skip setting this parameter.
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PM
OF ACC PKTS: 004OF ACC PKTS: 004
OF ACC PKTS: 004OF ACC PKTS: 004
OF ACC PKTS: 004
NUMBER OF HORN OFF PACKETS
This adjusts the number of times a “horn off” packet is sent when the HORN button is
released. The factory default is 2 but can be set as high as 16. Press ENTER to skip
setting this parameter.
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PM
HORN OFF PKT 002HORN OFF PKT 002
HORN OFF PKT 002HORN OFF PKT 002
HORN OFF PKT 002