56
SET THE SYSTEM CLOCK
(shortcut = PROG 3)
This allows the operator to start/stop the clock, set it, choose 12 or 24 hour operation, or
change the fast clock ratio.
STOPPING THE CLOCK
Press 1 to stop the clock, press ENTER to leave the clock running and continue with
clock programming. If the clock is already stopped, you will be prompted to start it.
STOP? 02:00PMSTOP? 02:00PM
STOP? 02:00PMSTOP? 02:00PM
STOP? 02:00PM
ENTER=NO 1=STOPENTER=NO 1=STOP
ENTER=NO 1=STOPENTER=NO 1=STOP
ENTER=NO 1=STOP
SETTING 12 or 24 HOUR MODE
Press 1 for 12 hour mode, press ENTER for 24 hour mode.
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PM
1=12HR 2=24HR _1=12HR 2=24HR _
1=12HR 2=24HR _1=12HR 2=24HR _
1=12HR 2=24HR _
ENTERING THE HOUR
Enter the starting hour in 24 hour format. For times in the A.M. use 0 to 11. For times in
the P.M. use 12 to 23. Press ENTER.
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PM
ENTER HOURS: _ENTER HOURS: _
ENTER HOURS: _ENTER HOURS: _
ENTER HOURS: _
ENTERING THE MINUTE
Enter the starting minute. Use 0 through 59. Press ENTER.
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PM
ENTER MINUTES: _ENTER MINUTES: _
ENTER MINUTES: _ENTER MINUTES: _
ENTER MINUTES: _
ENTERING THE RATIO
Enter the ratio that the clock should run at with 1 being the normal speed. The ratio can
be any number from 1 (1:1) to 15 (15:1). Press ENTER.
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PM
ENTER RATIO: _ENTER RATIO: _
ENTER RATIO: _ENTER RATIO: _
ENTER RATIO: _
STARTING THE CLOCK
If the clock was stopped, entering SET THE SYSTEM CLOCK will display this screen to
let you start (or restart) the clock. Press 1 to start the clock, press ENTER to leave the
clock stopped and continue with clock programming (see above).
START? 02:00PMSTART? 02:00PM
START? 02:00PMSTART? 02:00PM
START? 02:00PM
ENTER=NO 1=STARTENTER=NO 1=START
ENTER=NO 1=STARTENTER=NO 1=START
ENTER=NO 1=START
To Next Page
Loading...
