88
Please contact the Warranty Center for specific shipping instructions and any service
charges before returning any product for service. Address all inquiries to:
NCE Warranty Center
899 Ridge Road
Webster, New York 14580
Phone: 585-671-0370 Fax: 585-671-9337
Please check our web site: www.ncedcc.com to ensure that you have our latest address.
FCC Statement
This NCE product has been tested to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used
according to the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
Keep in mind that by FCC rules, all electronic equipment must accept any interference,
including interference that may cause undesired operation. If this equipment does cause
harmful interference to radio, or television reception, which is found by turning the
equipment off and on, the user is encouraged to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the device
Connect the equipment to an outlet other than the receiver’s
Consult a dealer or an experienced radio/TV technician for assistance
About NCE
NCE has been manufacturing DCC Products on an OEM basis since 1993. Originally we
offered only “chip sets” that contained software enabling other DCC manufacturers to
build DCC systems. As time went on some of those manufacturers asked us to first
supply partial assemblies then complete assemblies in addition to the chip sets. This has
helped NCE to grow into a full time electronic design and manufacturing firm devoted
entirely to the development and sale of products for the control of model railroads. We
build an amazing array of products for both our own customers and other DCC
manufacturers. We keep labor costs low by utilizing modern automated robotic assembly
for most products.
Our product designer is Jim Scorse. Jim models the Erie Railroad in O-Scale and has a
long history in model railroading. He has numerous patents in the area of digital imaging,
video and computer network data communications over noisy channels. Jim is active in
the Layout Design SIG as well as 32 years with the “Tuesday Night Gang”, (round robin
model railroad club) and is probably one of the only active model railroaders among all
the DCC manufacturers.
To Next Page
Loading...
