NDC BenchMike Pro User Manual

BenchMike Pro 2025/2050 & Z-Mike Pro 4025/4050 Instruction Handbook: Advanced Capabilities 5-3
5.1.1.4 Reserved Variable Names
Each feature contains a list of reserved variables, as listed in the following table. These variable names follow the
format:
fn.xxx
where n is the feature number and xxx is the reserved variable name.
For example, the size variable for feature #1 is f1.size, and the deviation variable for feature #20 is f20.dev.
Variable
Description
average
SQC average
count
SQC count
dev
Deviation from nominal
diff
SQC difference (maximum - minimum)
good
Count of “good” measurements (limits)
lrlim
Lower reject limit (-reject)
lrtol
Lower reject tolerance (-reject)
lwlim
Lower warning limit (-warning)
lwtol
Lower warning tolerance (-warning)
max
SQC maximum
min
SQC minimum
nominal
Nominal size
over
Count of “over” measurements (limits)
pos
Position in measurement area
pos.offset
Position in measurement area “offset”
sd
SQC standard deviation
size
Measured size
size.offset
Measured size “offset” (single point master)
under
Count of “under” measurements (limits)
urlim
Upper reject limit (+reject)
urtol
Upper reject tolerance (+reject)
uwlim
Upper warning limit (+warning)
uwtol
Upper warning tolerance (+warning)

NDC BenchMike Pro Specifications

General

Brand	NDC
Model	BenchMike Pro
Category	Measuring Instruments
Language	English