4-18
Security
Positioning the cursor to "Security" shows the following screen.
If you press Enter with the selection of either "Set Supervisor Password" or "Set User Password," such a screen as shown
below appears (the screen shown in the figure below appears when "Set Supervisor Password" is selected).
Specify the passwords on the dialog box. Enter each of the passwords with up to seven characters including alphanumerics and
symbols.
IMPORTANT:
Set the passwords only after operating system is installed.
If you forget the passwords, contact your service representative.
See the table below for the items.
Option Parameter Description Your Setting
Set User
Password
Up to seven
alphanumerics
Press Enter to display the user password input screen. For this
password, accessing to the SETUP menu is restricted.
Set Supervisor
Password
Up to seven
alphanumerics
Press Enter to display the supervisor password input screen. This
password enables all the SETUP menus to be accessed. This setting
can be done only on login with the password input of "Supervisor" at
start of SETUP.
Password on boot [Disabled]
Enabled
Specify whether the passwords are entered or not on booting. At first
the supervisor password must be set. If the supervisor password is set
and this option is invalid, BIOS determines that a user is booting.
Fixed disk boot
sector
[Normal]
Write Protect
Prevents data from being written to hard disks.
Secure Mode
Timer
[Disabled]
1 minute
2 minutes
5 minutes
10 minutes
20 minutes
60 minutes
120 minutes
Specify the period from no input from the keyboard or mouse to the
point at which the system enters into the secure mode.
Selectable only when
User Password is
registered
Selectable only when
User Password is
registered
To Next Page
Loading...
