9-14
3.5-inch Device
If th the additional HDD cage (with 3.5-inch bay) being built-in, one slot for backup device such as
a
T
A ailable Devices
T tain a single-height SCSI device.
–
ce can be connected to on-board SCSI interface. To use a tape device,
you purchased the server wi
magnetic tape drive is provided.
he additional HDD cage (with 3.5-inch bay) is a factory-installed option. You cannot purchase it separately.
v
he 3.5-inch device slot can con
Setting of SCSI ID
Refer to the manual that comes with the SCSI controller.
Setting of terminator
Set the terminator to "OFF".
IMPORTANT: No tape devi
connect it to optional SCSI controller.
Installation
Take the following
1. See the s described earlier to prepare.
e front bezel with the security key, and remove the front bezel.
screw and remove the additional tray.
steps to install the 3.5-inch device.
ection "Preparing for Installation and Removal"
2. Unlock th
3. Remove a
4. Pull the SCSI cable and power cable being formed in 3.5-inch device bay out of the server.
5. Insert the device into the additional tray and secure it with four screws.
To Next Page
Loading...
