2-22
POWER Switch
U on/off the server.
P er On
P on the front of the computer chassis.
The POWER/SLEEP lamp lights in green.
se the POWER switch to turn
ow
ress the POWER switch
IMPORTANT:
If the power cord is connected to a power control device such as a UPS (Un uptible Power
Supply), make sure that the power control device is powered.
If the power cord is connected to the server, an initial diagnosis of the hardware starts. The
POWER switch does not work while in diagnosis. Wait for about 10 seconds, then press the
P
D
T
may
interr
OWER switch.
o not turn off the server until characters following a full-screen logo appear on the screen.
he time until the characters appear depends on your system configuration. Approximately, it
take three to five minutes.
POWER switch
POWER/SLEEP lamp
To Next Page
Loading...
