4-29
Exiting from MegaRAID Configuration Utility
Press Esc in the TOP menu of MegaRAID Configuration Utility.
When a confirmation message appears, select [Yes].
When the above message appears, press Ctrl+Alt+Delete.
The server is rebooted.
Menu Tree
Setting list
+: Selection/execution parameter: Setting parameter. •: Information display
>: Can be set (modified) after creation of logical drive, #: Cannot be executed
Menu Description
+Configure
Performs Configuration settings
+Easy Configuration Set configuration (Using fixed value)
+New Configuration Set new configuration
+View/Add Configuration Additional setting / viewing configuration
+Clear Configuration Clear configuration
+Specify Bootable Logical Drive Chose Bootable Logical Drive
+Initialize
Initialize logical drive
+Objects
Various settings
+Adapter Set disk array controller
+Clear Configuration Clear configuration
*1 FlexRAID PowerFail Set whether to restart after rebuilding
*2 Fast Initialization Set high-speed initialization
*3 Disk Spin up Timing Set hard disk spin-up
*4 Cache Flush Timing Set cache flush timing
*5 Rebuild Rate Set rebuild rate
*6 Alarm Control Set alarm sound (ON / OFF)
+Other Adapter Information Board information display (FW version, etc.)
• FW Supports
FW type
• FW Ver
FW version
• BIOS Ver
BIOS version
• DRAM
Memory capacity
• Adapter Type
Board series NO.
+Factory Default Set default value
*7 Disable (Enable) BIOS Set BIOS Enable / Disable
+Battery Information Battery information
• Backup Module
Existence of battery module
• Battery Pack
Existence of battery pack
• Temperature
Battery temperature
• Voltage
Battery voltage
• Fast Charging
Set fast charging status
To Next Page
Loading...
