2-18
To enable this feature, you must select "Enabled" for "Wake On LAN/PME" in the Advanced Chipset Control of the Advanced
m
T POWER switch once to start the operating
sy
No eaker, disconnected power cord, power blackout, etc.)
enu of the BIOS setup utility, "SETUP." (See Chapter 4.)
he remote power-on feature is not available in the following cases. Press the
stem, and turn off the server in an appropriate procedure.
Abnormal previous system shut-down
power supply to the server (due to turned-off br
NOTE: Wake On LAN feature is supported in 100BASE-TX/1000BASE-T adapter on the I/O
board.
AC-LINK Feature
When the power cord of the server is connected to an uninterruptible power supply (UPS) unit, the server supports the power
link ntrol over the power supply from the UPS to the server. AC-LINK feature can be enabled or
d he Server menu of the BIOS setup utility, "SETUP." (See Chapter 4.)
S
age feature that enables co
isabled with "AC-LINK" in t
ecurity
T
M ent software that monitors the system intrusion switches.
S echanical Locks and Monitoring
T
T his cover is opened, the switch transmits
an alarm e signal.
S
T
Once the
ex
e after a
specified time-out period – 1 to 120 minutes.
Set and enable a user password
e a hot-key combination to enter secure mode quickly.
o help prevent unauthorized entry or use of the system, the system includes a full lockable front panel and Server
anagem
ecurity with M
he front bezel of the server contains a mechanical lock to prevent access to the front of the computer chassis.
he computer chassis includes an intrusion switch for the front access cover. When t
signal to the system board, where server management software processes th
oftware Locks via the System Setup Utility
he BIOS SETUP Utility provides a number of security features to prevent unauthorized or accidental access to the system.
security measures are enabled, access to the system is allowed only after the user enters the correct password(s). For
ample:
Enable the keyboard lockout timer so that the server requires a password to reactivate the keyboard and mous
Set and enable an administrative password.
Set secure mode to prevent keyboard or mouse input and to prevent use of the front panel reset, power and sleep
switches.
Activat
Disable writing to the floppy disk drive when secure mode is set.
To Next Page
Loading...
