9-12
Server ~ Pulling Out from the Rack Cabinet~
T ponents other than the hard disk drives and
po
he server needs to be pulled out from the rack for installing/removing any com
wer supply units.
CAUTION
Observe the following instructions to use the llow these instructions may
result in death or serious personal injury. See pages 1-3 to 1-8 for details.
server safely. Failure to fo
Do
Do t
not install the server on a rack with leaving covers removed.
not pinch your finger with mechanical components.
high temperature.
Do
o
N te
no
pull out a device from the rack if the rack is unstable.
not leave more than one device being pulled out from the rack.
Do
1. See the section "
2. Remov he fron
Preparing for Installation and Removal" described earlier to prepare.
e t t bezel.
frame
Tab
3. Loosen the four screws from the front of the server.
Screws
Screws
4. Slowly pull out the server
heard.
When inserting th
Be very careful not to get your finger caught in doing so.
IMPORTANT: Push the release lever using a screwdriver or the like. Pushing the lever with your
from the rack while pushing the release lever. The server is latched when a "click" is
e server back into the rack, push the release levers on the rails on the sides of the server to unlatch the server.
finger may hurt your finger.
To Next Page
Loading...
