8-4
STATUS lamp
indication
Description Action
The server is in operation with its memory
degraded.
Contact your service representative.
Start the BIOS SETUP and select [Advanced] - [Memory
Configuration] to identify the degraded memory (DIMM) and
replace it as soon as possible.
Or, start the BIOS SETUP and select [Advanced] - [Memory
Configuration] - [Memory Retest] - [Yes], and then select [Exit]
- [Exit Saving Changes] to solve the problem.
Flashing in
green
A correctable memory or bus error was
detected.
The system can continue operation if the status lamp flashes
green. However, consult with your service representative.
The server is off-powered.
Power on the server.
POST is in progress.
Wait for a while. The STATUS lamp will light in a few seconds
after POST completion.
A processor error occurred (IERR).
A processor thermal error was detected.
(Thermal-Trip)
A watchdog timer has timed out.
A PCI system error occurred.
A PCI parity error occurred.
An uncorrectable memory error was
detected.
An uncorrectable bus error was detected.
POST terminates with error.
Cycle power to the server. If POST displays an error message,
take a note on the message and contact your service
representative.
Unlit
Memory dumping is requested.
Wait until memory dumping completes.
A thermal error (critical) was detected.
Check internal fans for dust or debris. Also make sure that the
fans are firmly connected.
If this error indication persists, contact your service
representative.
A voltage error (critical) was detected.
Contact your service representative.
Lit in amber
A power supply (ies) failed to operate.
Contact your service representative.
A power alarm was detected in a power
supply unit.
Identify the failed power supply unit and contact your service
representative.
A fan alarm was detected.
Make sure that the fan units are firmly connected.
If this error indication persists, contact your service
representative.
A thermal error (warning) was detected.
Check internal fans for dust or debris. Also make sure that the
fan units are firmly connected.
If this error indication persists, contact your service
representative.
Flashing in
amber
A voltage error (warning) was detected.
Contact your service representative.
DISK ACCESS Lamp
The DISK ACCESS lamp indicates the state of hard disks in the 3.5-inch disk bay.
This lamp lights in green every time any of such hard disks is accessed.
When the DISK ACCESS lamp is lit in amber, it indicates that a hard disk error occurred. To identify a failed hard disk, see the
lamps provided for each hard disk.
DISK ACCESS lamp
To Next Page
Loading...
