8-34
Problems with Windows Server™ 2003 and Windows® 2000
Cannot install the operating system correctly.
• Did you confirm the notes on installing the operating system?
→ See Chapter 6.
During Windows 2000 installation, the following warning is registered in the System Log of the Event Viewer:
Error detected on the device \Device\CdRom0 during the paging operation.
→ There is no problem on this issue.
Fail to start the operating system:
• Is a floppy disk in the floppy disk drive?
→ Take out the floppy disk and restart the server.
• Is the EXPRESSBUILDER CD-ROM in the CD-ROM drive?
→ Take out the EXPRESSBUILDER CD-ROM and restart the server.
• Is the operating system broken?
→ Use recovery process to recover the system.
(See "Recovery for Windows 2000" in this Chapter.)
The event log after every logon to Windows 2000 includes the following error log:
Description (D)
The CPUs in this multiprocessor system are not all the same revision level.
To use all processors the operating system restricts itself to the features of
the least capable processor in the system. Should problems occur with
this system, contact the CPU manufacture to see if this mix of processors
is supported.
• Has the processor been expanded?
→ If the different revision (stepping) of the processor is installed in the multiprocessor system, Windows
2000 logs the above information every startup. If this message is logged, it is no problem for
operation.
The operating system presents unstable operation:
• Did you update the system?
→ Installing a network drive after installation of the operating system may cause unstable operation. Use
the EXPRESSBUILDER CD-ROM to update the system. (See Chapter 6.)
When any trouble occurred, the system does not run according to the specification of "Restart automatically":
→ When any trouble occurred on Windows 2000, the system may not restart automatically even if
"Restart automatically" is specified. In such case, restart the system manually.
Cannot turn the power OFF at the blue screen:
→ If you want to turn off the power at the blue screen, execute forced power off (forced shut down:
continue to press POWER switch for 4 seconds). The power will not be turned off if you press the
switch just one time.
To Next Page
Loading...
