9-19
PCI Access Cover
T p PCI board, remove the PCI access cover inside the server. You need not to remove the PCI
ac
R oval
section "Preparing for Installation and Removal" described earlier to prepare.
the rack.
3. m
4. o er.
5. he screw is loosened), and take out the cover slowly and gently.
o install or remove a non-hot-swa
cess cover when you work with hot-swap PCI slot.
em
1.
See the
2. Pull out the server from
Re ove the rear access cover.
Lo sen the screw securing the PCI access cov
Hold the end of the cover (the end where t
Installation
Take the following steps to install the
1. Orient the PCI access cover
2. Insert the tab on the rear side of the PCI access cover into the chassis slot.
3. Slowly and gently put the cover on the chassis, and secure it with a screw.
PCI access cover.
with the screw toward the front of the server.
To Next Page
Loading...
