Appendix A
Specifications
Model type at shipment Diskless
Type
64bit Intel
® Xeon® Processor MP
Dual-core Intel
®
Xeon
® Processor
7040
Clock/2nd cache
3.16GHz
/ 1MB
3.66GHz
/ 1MB
2.83
6GHz /
4 MB
3.0
GHz /
8MB
3.33
GHz /
8 MB
2.66GHz
/ 2*1 MB
3.0 GHz
2 * 2 MB
Number of processors 1
Processor
Maximum 4
Chipset Intel® TwinCastle + ICH5 + Dobson + PXH
Standard 2 GB (1GB × 2)
Maximum 32 GB (The standard DIMM must be replaced.)
Expansion unit 2 DIMMs
Expansion times Maximum 8 times (2 times per each memory board)
Memory module DDR2 400 SDRAM DIMM (Registered)
Error check ECC
Memory
Memory mirroring feature
Online sparing memory feature
Memory Hot-add/Hot-replace
feature
Memory RAID feature
Supported
Graphics (VRAM) ATI® Radeon® 7000M (VRAM 16MB)
Floppy disk (standard) –
Hard disk (standard) –
Hard disk (maximum) 1500 GB (300 GB × 5)
Auxiliary
input device
CD-ROM (standard) ATAPI Interface × 1 (Load on tray type, x24 speed)
3.5-inch device bay
1 slot (half height)
(when N8154-07F HDD cage is installed.)
3.5-inch disk bay
Up to 5 slots (Hot-swappable) (Normal installation)
Up to 3 slots (Hot-swappable) (when N8154-07F HDD cage is installed.)
PCI-X 100MHz (64-bit) 4 slots (Hot-swappable)
PCI 33MHz (32-bit) 2 slots
PCI EXPRESS(x8) 2 slots (Hot-swappable)
Additional
slot
PCI EXPRESS(x4) 1 slot
LAN interface 1000BASE-T/100BASE-TX/10BASE-T (2 ports)
LAN interface (A-RMC) 100BASE-TX/10BASE-T (1 port, dedicated for server management)
Keyboard MINI DIN 6-pin connector (1 port)
Mouse MINI DIN 6-pin connector (1 port)
USB 4-pin (3 ports; front: 1 (USB 1.1), rear: 2 (USB 2.0))
Serial
D-sub 9-pin (2 ports, rear), RJ-45 (1 port, front (exclusively used with
either port on the rear panel))
Parallel D-sub 25-pin (1 port)
Network RJ-45 (2 ports and 1 management port)
Display MINI D-sub 15-pin (1 port)
SCSI –
Cabinet design 19-inch rack mounting type (4U)
External dimensions 483 (width) × 178 (height) × 738 (depth) mm
Weight 47 kg (Max.)
Power supply 100 to 127 Vac ±10%, 200 to 240 Vac ±10%, 50/60 Hz ±1Hz
Power consumption 1200 VA
Temperature 10 to 35°C
Environmental
requirements
Humidity 20 to 80% RH (no condensation)
Others
EXPRESSBUILDER supported, ESMPRO provided in the standard
configuration
To Next Page
Loading...
