9-54
Removal
T cessor, prepare the removal referring to steps 1 and 5 in the installation procedure and do the reverse
p
o remove the pro
rocedure of steps 8 to 12.
IMPORTANT:
D is failed.
T fect in the server, the dummy cover is installed in the empty slot. Be
s t not installed.
A
pr
right
s w
o not remove any processor unless it
o maintain the cooling ef
ure o install the dummy cover to the slot where the processor is
fter the operation, heat may make the cool seat at the bottom of the heat sink adhere to the
ocessor. To remove the heat sink from the processor, first turn the heat sink to the left and
lightly to make sure that the heat sink can be apart from the processor. Removing the heat
ink ith it adhering to the processor may cause the processor and/or socket to be damaged.
Take the following pro
1. Start SETUP
information o
confirm that the ID and L2 and L3
2. le
Thi hapter 4 for details.
cedure if a processor is removed (or replaced).
to select menus "Main" – "Processor Settings" – "Processor Retest" in the order to clear the error
n the removed processor (see Chapter 4).
When a processor is replaced, select menus "Main" – "Processor Settings" to
Cache of the additional processor are defined normally (see Chapter 4).
Se ct "Yes" for [Reset Configuration Data] on the Advanced menu.
s is required to update the hardware configuration information. See C
To Next Page
Loading...
