9-53
12. Tighten the four screws to secure the heat sink.
13. Make sure that the heat sink is level.
IMPORTANT: If the heat sink is not level, remove it, and check if the processor is positioned
correctly.
14. Fully open the levers on both sides of VRM socket.
15. Push the VRM straight into the socket.
When the VRM is inserted into the socket toward inside to securely
close the lever.
NOTE: Make sure the orientation of VRM. prevent
, the lever automatically closes. Push the lever
The terminal side of VRM has a cut-o
ut to
the incorrect insertion.
16. Install the components you removed previously.
17. Start SETUP and select "Yes" for [Reset Configurat
This setting is required to change the hardware co tails.
18. To add one or more processors to the server in 1- server with more than one
processor, do the procedure below:
For Windows Server 2003 or Windows 2000, ch e manager to [ACPI
multi-processor PC] and then update the system (s
ion Data] on the Advanced menu.
nfiguration data. See Chapter 4 for de
processor configuration to operate the
ange the driver of [Computer] in the devic
ee Chapter 5).
To Next Page
Loading...
