9-38
Memory Board
T M, remove the memory board first.
O 2GB max.) can be installed in the server.
T
h
o install or remove the DIM
ne memory board is factory-installed in the server. Up to four memory boards (3
he failing DIMM or memory board can be hot-swapped (replacement with power-on state) if the redundant memory boards
as been configured. For hot-swap memory board, see "DIMM" described later in this chapter.
Removal
Remove the memory bo
IMPORTA
ard as described in the following procedure.
NT:
The memory board is extremely sensitive to static electricity. Make sure to touch the metal
frame of the server to discharge static electricity from your body before handling the memory
y a bare hand or place the
described earlier.
T es very hot while being powered. When removing the board, turn off
the
board. Do not touch the memory board terminals or on-board parts b
memory board directly on the desk. For static notes, see the section "Anti-static Measures"
he memory board becom
power and wait for several minutes before pulling it out.
1. See the sectio
2. Unlock the fr
3. Remove the t the memory slot cover at the front of the server.
n "Preparing for Installation and Removal" described earlier to prepare.
ont bezel with the security key, and remove the front bezel.
wo screws, and remove
Memory board slot #3
(for additional memory
board)
Memory board slot #4
(for additional memory
board)
Memory board slot #2
(for additional memory
board)
Memory board slot #1
(for factory-installed
memory board)
To Next Page
Loading...
