9-18
Rear Access Cover
T r to change cable connections of internal SCSI cable, you will need to remove the rear
ac
o install or remove the PCI board, o
cess cover.
CAUTION
Observe the following instructions to use the ow these instructions may
result in death or serious personal injury. See pages 1-3 to 1-8 for deta s.
server safely. Failure to foll
il
Be sure to power off the server before removing the rear access cover.
Removal
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
the server from the rack.
3. Loosen the captive screws located on the rear of the cover.
4.
5.
ft
2. Pull out
Slide the rear access cover toward the rear of the chassis.
Li the cover up and off of the chassis.
Installation
IMPORTANT
cover, check that you have not left tools or loose : Before installing the rear access
parts inside the system.
1. Position the cover on the chassis so that the cover tabs align with the chassis slots.
2. While lightly pressing down on the cover, slide it toward the front of the chassis.
over to the chassis with the captive screws located on the rear of the cover.
3. Attach the c
Captive screw
Captive screw
To Next Page
Loading...
