9-20
PCI Board
T ix slots for PCI board, and three slots for PCI-Express board.
S wer of the server being
on
bo
he server contains s
ome PCI boards support the hot-plug function by which they may be installed or removed with the po
. Your server supports the hot-plug function if Windows Server 2003 or Windows 2000 is used as operating system. The PCI
ards supporting the hot-plug function only include the 100BASE-TX Adapter and the 1000BASE-T Adapter.
IMPORTANT: The PCI board is extremely sensitive to static electricity. Make sure to touch the
metal frame of the server to discharge static electricity from your body before handling the PCI
board.
boar
Do not touch the PCI board terminals or on-board parts by a bare hand or place the PCI
d directly on the desk. For static notes, see the section "Anti-static Measures".
NOTE: The tab on the PCI board slot indicates hot-plug or non-hot-plug by its colour. Hot-plug
slot has a g
through #3).
reen tab (PCI slot #4 through #9), and non-hot-plug slot has a blue tab (PCI slot #1
There are three types of PCI boards: 5V PCI bo
A 5V PCI board must be installed in the 5V PCI slo
PCI board can be installed in any PCI slot.
ards, 3.3V PCI boards, and universal PCI boards.
t, and a 3.3V PCI board must be installed in the 3.3V PCI slot. A universal
5V PCI board 3.3V PCI board Universal PCI board
T
he PCI-Express boards are x1, x4, x8, and x16. The server can contain x1, x4, and x8 PCI-Express board.
PCI-Express board (x4) 8) PCI-Express board (x
Non-hot-plug PCI board slots
(color: blue)
Hot-plug PCI board slots
(color: green)
PCI #1, #2 (32-bit/33MHz, 5V PCI)
PCI #3 (PCI-Express (x4))
PCI #4, #5 (PCI-Express(x8))
PCI #6, #7, #8, #9
(64-bit/100MHz, 3.3V PCI-X)
To Next Page
Loading...
