4-30
Menu Description
• No of Cycles
The number charge cycle
+Reset Battery Charge Counter Clear battery charge counter
+Other Adapter Options Adapter detailed options
*8 Emulation Set control mode
*9 Auto Rebuild Set auto rebuilding Enable / Disable
• Initiator ID
Indicate Initiator ID No.
*10 Cluster Mode Set cluster mode
*11 Multiple PCI Delayed Trans Set PCI bus bridge
*12 Force Boot Forced setting of configuration information(HDD)
*13 Coercion Algorithm Setting parameter for maximum hard disk capacity
Abort BI & CC Activities Abort Background initialize or Check Consistency
*14 CC Restoration Select CC Restoration mode
*15 Temporary Offline RAID Set Temporary offline Enable / Disable
+Logical Drive Logical drive operation
+Logical Drives Select logical drive
+Initialize Initialize logical drive
+Check Consistency Check logical drive redundancy
+View/Update Parameters Display logical drive information
• RAID
Display RAID level
• SIZE
Display logical drive capacity
• Stripe SIZE
Display stripe size
+√ Write Policy
Set write mode
+√ Read Policy
Set read mode
+√ Cache Policy
Set cache mode
+√ FlexRAID Virtual Sizing
Set virtual sizing Enable / Disable *Do not set to Enable
• #Stripes
Display stripe size
• State
Display logical drive status
+Physical Drive Physical drive menu
+Physical Drive Selection Menu Physical drive operation
+Rebuild Perform rebuilding
+Format Perform low level format
*Do not use
+Make Online Set the disk online
+Fail Drive Set the disk offline
+Make HotSpare Set as stand-by disk for auto rebuilding
+View Drive Information Display hard disk information
• Device Type
Hard disk type
• Capacity
Hard disk capacity
• Vender ID
Hard disk vender name
• Product ID
Hard disk model
• Revision
Hard disk revision
• SCSI Standard
SCSI standard
• Media Errors
The number of media errors
• Other Errors
The number of other errors
*16 Synchronous Negotiation SCSI synchronous negotiation
*17 SCSI Command Q Tagging Set SCSI command Q Tag
+Channel Set channel
+Channels Chose SCSI channel
*18 Termination State Set termination state
*19 Enable Auto Termination Set auto termination state
*20 SCSI Transfer rate Set transfer rate
+Format Perform low level format
*Do not use
+Rebuild Perform rebuilding
+Check Consistency Perform logical drive redundancy check
+Select Adapter Select disk array controller
* This menu item does not appear if no disk array controller is installed in the
computer.
To Next Page
Loading...
