4-31
Setting values
No. Setting parameter Factory setting Setting change
*1 FlexRAID PowerFail ENABLED Do not change
*2 Fast Initialization ON Variable setting
*3 Disk Spin-up Timing 2 disks every 6 seconds Do not change
*4 Cache Flush Timing Every 4 Seconds Do not change
*5 Rebuild Rate 30% Variable setting
*6 Alarm Control Disable Alarm Do not change
*7 Disable(Enable) BIOS Enable (Display: Disable BIOS) Do not change
*8 Emulation MASS STORAGE Do not change
*9 Auto Rebuild ENABLED Do not change
*10 Cluster Mode DISABLED Do not change
*11 Multiple PCI Delayed Trans ENABLED Do not change
*12 Force Boot ON Do not change
*13 Coercion Algorithm NONE Do not change
*14 CC Restoration ENABLED Variable setting
*15 Temporary Offline RAID ENABLED Do not change
*16 Synchronous Negotiation Enabled Do not change
*17 SCSI Command Q Tagging Enhanced QTAG Scheduling Do not change
*18 Termination State Enabled Do not change
*19 Enable Auto Termination No Do not change
*20 SCSI Transfer rate 320M Do not change
Changing factory settings
The settings for the following items can be changed. Follow each explanation:
*2 Fast Initialization
A setting of "On" is recommended.
This initializes the top area of the disk only.
*5 Rebuild Rate A setting of "30%" is recommended.
*14 CC Restoration Factory setting is "ENABLED".
IMPORTANT:
Notice status display of "Disable (Enable) BIOS".
Selected Enable : Indicate "Disable BIOS"
Selected Disable: Indicate "Enable BIOS"
When "Factory Default" is executed, the setting values are changed.
Set each parameter after executing "Factory Default."
Some versions of MegaRAID Configuration Utility change the "Factory Default" setting value.
Check each parameter setting after executing "Factory Default."
The server must be restart after executing "Factory Default."
To Next Page
Loading...
