4-33
IMPORTANT: The channel number displayed on MegaRAID Configuration Utility is different
form hardware channel number printed on the controller board.
Channel number printed on the board CH0 CH1
Channel number displayed on MCU Channel-1 Channel-2
6. When the hard disk is selected, press Enter to fix the selection (blinking stops.)
7. Press F10 to create logical drive. The "Logical Drives Configure" screen appears.
8. Select "RAID," "Size" or "Advanced Menu" by using cursor keys. Then press Enter to fix the selection and set each
value. Selecting "Advanced" displays the Advanced screen.
– "RAID": Sets RAID level.
Parameter Remarks
0 -
1 -
5 -
The selectable RAID level varies depending on the number of hard disks that configure a pack.
– "Size": Sets logical drive size.
Up to 40 logical drives can be created per disk array controller.
To Next Page
Loading...
