4-55
Network Configuration
IMPORTANT:
Before setting the default gateway, the gateway, the server, and the management PC must be
ready to communicate.
If the default gateway is set while they are not ready to communicate, you must cycle the
power of the server after they are ready to communicate through network.
The ports listed below are used for remote management.
If your network has a firewall, provide setting for firewall appropriately.
Module name Port number Protocol Direction Module name Port number
Remote KVM client Undefined UDP
←→
BMC 623
Mail server 25 (*1) TCP
←→
BMC Undefined
WEB client Undefined TCP
←→
BMC 80 (*2)
WEB client (SSL) Undefined TCP
←→
BMC 443 (*3)
*1: To change the port number, select [BMC Settings] → [Alert Mail] → [E-Mail Alert Settings] → [SMTP] → [SMTP Port
Number].
*2: To change the port number, select [BMC Settings] → [WEB Server] → [WEB Server Settings] → [HTTP Port Number].
*3: To change the port number, select [BMC Settings] → [WEB Server] → [WEB Server Settings] → [SSL Port Number].
By clicking [Network Configuration] in the left pane of the BMC Configuration window, you will see a window as shown
below and you can make network-related settings for BMC including IP address.
When you click [
], the icon for editing information, in this window, the Network Configuration window as shown below
appears.
The Network Configuration window has three tabs.
To Next Page
Loading...
